Refinery & Gas Process Chemicals

Three-phase amine inhibitor for protection from H2S, CO2, organic acids, and mineral salts. Miscible in all phases of oil, water, and gas, which is very important to ensure that the fluid plates properly.                                                                   

Oil soluble, filming amine type inhibitor for sour well surface facility protection from CO2, H2S, chlorides, and organic acid corrosion.     

Water soluble inhibitor corrosion control in gas scrubber units. It is Þ typically loaded from 100 - 300 ppm in the scrub liquor.            

Organic inhibitor/surfactant in alcohol base solvent for treatment in dry gas environments. OILAID-CI-201A is soluble in fresh water and low brines. It provides excellent protection against hydrogen sulfide and carbon dioxide in dry gas environments where a water soluble or alcohol soluble inhibitor is required. This inhibitor is a non- gunking material that is formulated for use in a dry environment.                                                                                            

Oil soluble film forming corrosion inhibitor for protection againstÞ hydrogen sulfide, carbon dioxide, and salt water corrosion. OILAID- CI-206 is designed to provide a persistent film not only to the primary working parts of the well, but also throughout the crude gathering lines, storage tanks, and pipelines. For continuous injection.                                                                                            

Oil soluble, filming inhibitor for protection in natural gas and gas/condensate handling systems. It shows no tendencies to cause foaming. Normally it is continuously injected at a loading range of 5 - 10 ppm, but may also be batch mixed.                                                   

Water soluble liquid amine inhibitor designed to reduce corrosion in refinery overhead systems. OILAID-CI-500 also helps reduce fouling of inorganic deposits associated with ammonium-type neutralizers. It protects against corrosion caused by local pitting. This often occurs in overhead exchangers of distillation units where corrosion begins.                                                                                  

An oil soluble filming nitrogen condensate inhibitor designed to reduce corrosion from hydrogen chloride salts in distillation column systems. Severe corrosion is possible in this type of system due to the low pH of the initial condensate (usually 1 to 2). OILAID-CI-501 is normally run through a positive displacement pump. It should be continuously injected into the system ahead of any existing areas where potential corrosion is a problem. The dosage of OILAID-CI-Þ 501 necessary for each application will depend on the acid content of the particular system being treated, and whether any other inhibitors are also being employed. It is highly recommended that a total monitoring system be initiated, but a typical dosage of 3 to 5 ppm will normally alleviate any problems encountered.                                                                                           

An excellent corrosion inhibitor, which provides a very tenacious film for hydrocarbon processing systems, as well as for gas cracker recovery systems, for protection against H2S over a wide pH range.            

Water and brine soluble inhibitor for refinery overhead systems. It is applicable in systems with or without the presence of hydrocarbons, such as wet production, water injection, and desalting wash waters.